Hand Impulse Sealer Use And Maintenance

Use and maintenance of Hand impulse sealer

Hand Impulse Sealer is a relatively simple products in sealing machine, compared to other sealing machine, it is not only small , easy to carry and use relatively simple.
Hand Impulse Sealer no power switch. Put the AC power cord into the outlet, according to the thickness of the sealing material, adjusting the heating time. The plastic bag sealing surface, then press the handle, the circuit automatically controls the heating time. When hand impulse sealer light is off, the power supply automatically gets disconnected. After about 1-2 seconds, release the handle, the seal better.

Then sealed at a time appears damaged (which is often the fault of the plastic sealing machine), usually because the heating time is too long. Only the knob counter-clockwise direction to shorten the heating time.
If the seal is not strong, it is because the heating time is too short. Please sealer knob is rotated clockwise, plus extended time. If plastic bags stuck to the rubber plate, indicating that the cooling time is not enough, it must extend the cooling time after the light goes out. Please little later release handle. Adjust heating time after use should remain unchanged. In continuous use do not have to make any adjustments to the machine can always plug the AC power cord into the power outlet, when not seal does not consume electricity SF-200B has a function of typing, typing if needed, will in turn use the rubber platen.
In the normal maintenance of hand pressure type sealing machine aluminum foil sealing machine, although not critical, but it should always be kept clean sealing surface, into the residue-free sealing surface of oxidized and reduced heat cloth band life. Do not rub the sealing surface with a damp cloth.
If the sealing gasket below electromechanical tropical damaged, it will cause a short circuit and damage the heating cable. So every time you replace the band, should check the integrity of that pad. If damaged should be replaced with new. Required want to change the band should check to see rubber platen after selection has the same specifications as the original long-term use. Because the rubber platen is damaged will affect the sealing quality.