These Five Points Need To Pay Attention To When Using The Continuous Band Sealer

In the process of using the continuous band sealer, in addition to sealing operations in accordance with the correct operating steps, some matters in the process of use also need our attention. The following five points should be done well, which will be very important for our future use. help.

1. During the operation of the continuous band sealer, if it is found that there is dirt adhered to the heating block and there is also dirt in the sealing place, the operation should be stopped to remove the dirt. Remember that when the temperature of the device is too high, do not directly touch the dirt with your hands to avoid burns.

2. When debugging the film temperature, the temperature should be gradually increased from small to large until the film continuous band sealer (heat sealing) temperature is appropriate, but the temperature cannot be adjusted from high to low, otherwise it is easy to burn off the heating wire, burn out the electric heating tape and press gum.

3. When the continuous band sealer is not sealed, it is strictly forbidden to idle the equipment. When the equipment is not operated for a long time, the machine should be shut down in time to avoid wasting resources on the equipment.

4. When the continuous band sealer is in operation, do not put your hand on a high-temperature cloth with high temperature to avoid injury.

5. If the continuous band sealer is not used for a long time, it should be cleaned regularly to prevent dust from contaminating the equipment.