How To Use Milk Tea Cup Filling Sealing Machine?

(A) wear film

a. When you get the film, you need to confirm the winding direction of the film, find out the counterclockwise direction, and put it on the film bar of the milk tea cup filling sealing machine to fix it. (Please turn off the power when wearing the film);

b. Pay attention to whether the front and rear fixing splints of the film are tightly combined with the film. If it cannot be tightly connected, use a utility knife to cut the inside of the film paper tube at an angle before putting it in;

c. After putting on the adhesive film, stick the adhesive film firmly on the receiving paper tube with adhesive tape.

(Two) sealing operation steps (panel operation instructions)

a. The milk tea cup filling sealing machine is powered on, the power switch is turned on, the indicator light is on, the lower slide plate automatically slides out of the machine to set the temperature controller to a predetermined temperature, and the green heating indicator light is on. When the hot plate reaches the predetermined temperature, the red constant temperature indicator lights up (the electric heating device alternates between the heating and holding states when the sealing machine is working, so the green and red indicators continue to alternately display, which is normal)

b. Put the plastic cup into the lower mold slide, press the fully automatic control switch, the lower mold slide automatically enters, touches the rear stroke switch, the upper mold automatically presses the seal after receiving the signal, and the lower stroke switch delays Press for one second, it will automatically rise and reset. When the upper stroke switch is touched, the upper mold motor will stop. The film motor will start to rotate. After a predetermined length, the film motor will stop automatically by the electric eye.Move the control switch, you need to press the start button to start a cycle;

c. In any case, press the stop button, the lower mold slide of the milk tea cup filling sealing machine will automatically slide out of the machine.