Winding Packing Machine: How To Deal With The Automatic Luggage Wrapping Machine Is Not Sticky

First, analyze the process and principle required by the strapping machine to summarize and summarize the multiple causes of the failure, and check them one by one. The troubleshooting process is from easy to difficult, that is, starting from the component machine that is prone to the failure.

1. The temperature of the hot head of the baler is too high or too low, the temperature of the hot head is too high, the temperature of the packer is not enough to melt and bond the packing belt, or the bonding is not strong, but the bandage is too high. The temperature is too high, especially the adhesive part of the semi-automatic packing belt is melted too much under high temperature melting, and the most effective bonding cannot be achieved, resulting in a packing bandage.

2. The quality of the packing belt, due to the different parameters of the packing machine during the packing process, such as tension, temperature, etc., the adjustment of the tightening force is adjusted according to the packing material quality. , The maximum load-bearing tightening force can be adjusted to adjust the parameters of the baler. If it is too high, the bandage will be broken.

3. The cutter or bonding station of the baler cannot operate normally. The cutter and the bonding station of the baler are the key to the bonding of the strapping belt. The gap between the two is too large to make the strapping belt intact. It will be bandaged after the packing is completed, so there is no adjustment part for the gap between the cutter and the iron. The main control method is to pay attention to maintenance, pay attention to the use of the cutter of the packer, and pull.

The progress control of the spring. If the tension of the spring cannot pull the bonding table smoothly into place, there will be a gap between the two, resulting in unfavorable binding of the strap and bandage failure.