Use Attention Of Sealing Machine And Sealing Machine Cleaning And Maintenance

Operation process Note
1, this machine uses 220V single phase three wire power supply, the grounding must be reliable, otherwise it will affect the safety of people.
2, metal parts can not be close to the sensor head.
3, often check the cooling water level, the general frequent use, check once a week, and added cooling water. It is best to use non conductive cooling water.
4, often check the pipe, joints can not have leakage, water seepage phenomenon. In order to prevent the pipeline from freezing due to low temperature, the water tank should be injected into the antifreeze solution.
5, maintenance should follow the operation sequence.
6, maintenance should be fixed professional.
7, the boot is not allowed to open the case, check the maintenance must be cut off the total power supply.
8, machine design has the overload and overheat protection system. When the cooling plate temperature over 70 degrees will cut off the high voltage, lights flashing: load (by heating cap diameter is too large or arranged closely or distance sensor head too close, causing machine high-voltage current instantaneous overload (more than 100 digital instantaneous) can also be protected. This is a normal phenomenon, you can re press the START button to start.
Cleaning and maintenance
Regular cleaning machine surface, bottom plate and the lower mold plate, groove, upper mold plate and positioning rod (Note: must be shut down power and return to normal temperature).
The driving parts of the lower mold plate, the roller bearing, the eccentric wheel and the guide column, the guide rail and other transmission parts are regularly added to ensure the machine’s performance.
Cleaning cutter method: first with a cotton ball will die two scuppers plugged, boiling water is poured into the die groove, poured so far, then push the die slide in place, the mold under pressure, pressure to the lowest point, make tooth knife soaked for several minutes to clean so far and repeated several times.