Installation and Replacement Method of Hand Impulse Sealer Wheel

Installation and replacement of hand impulse sealer wheel as following:

1, remove the defense cover, reverse rotary knob Songhua wheel pressure.

2, remove the guide rubber belt, unscrew the fastening screw wheel axis.

3, use a screwdriver to pry the wheel seat, the wheel and rubber wheel left a little distance, pulled out by hand wheel printing. Then mounted on the wheel. On the wheel axis oriented installed fastening screws, rubber belt, adjust the wheel pressure to start commissioning.

Cleaning hand pressure plastic bag sealing machine cutter method: first with a cotton ball will die two scuppers plugged, boiling water is poured into the die groove, poured so far, then push the die slide in place, the mold under pressure, pressure to the lowest point, make tooth knife soaked for several minutes to clean so far and repeated several times.