Operation Procedure Of Continuous Sealing Machine

Seven keys about continuous sealing machine's operation procedure:

1, on the power and press the start switch, the indicator light, adjust the speed control knob, the transmission parts, namely synchronous operation.

2, fine tune the printing wheel knob, so that the printing wheel rotation. Adjust to the appropriate pressure, and then fix the limit screw.

3, connected to the heating switch, electronic temperature control instrument of the green light. According to the material and the thickness of the packing bag to adjust the temperature to the required temperature, heating block, starting at the same time, starting at low speed operation.

4, as the material and thickness of the plastic bag, determine whether to open the fan cooling.

5, bag packing seal should be aligned flat, the bag by flat regulation by bit (feed) into, when the seal is sealed with bite the packing bag automatic moving forward, then do not arbitrarily promote or block, otherwise it will cause sealing wrinkly fold or fault.

6, when the sealing belt and the heating block adhesion dirt, should stop cleaning, when the temperature is too high do not directly by hand to remove.

7, in order to improve the service life of the seal, in the preparation before the shutdown, the temperature adjustment knob is required to return to zero, open the blower, then the temperature pointer began to slow down, sealing tape should be still running. After a few minutes, the temperature dropped to the following l00C, the side can turn off the fan and the total power switch.