Brief Introduction of Plastic Sealing Machine

Plastic sealing machine brief introduction as following:

Use

1 Press the start switch, turning on the power supply indicator, adjust the speed control knob, the transmission parts namely synchronous operation.

2 heating to switch, green light is electronic temperature controller. According to the packing bag of material and thickness control temperature controller to the required temperature, heating blocks began to preheat, speed should be switched on at the same time.

3 depending on the blocked the material and thickness of plastic bags, determine whether need to open the fan cooling. Pincer-like device should be aligned flat, packet contents by flat regulation by a (inlet) into, to make packages automatically when pincer-like device is the sealing belt bite marching forward, not any push or stand at this time, otherwise it will cause the sealing knit fold or fault.

Note

1 don’t put your hands on high temperature cloth in the process of work, in case of hurting hands.

2 if I found the sealing belt and the heating block adhesion dirt, should stop to clear, clear do not directly with the hand when the temperature is too high.

3 a day to clean up the surface, is infected with dirt not

4 it is strictly prohibited to equipment idle, long time no work must close the machine, lest cause waste of resources

Common fault processing method

a common problem of continuous sealing machine, bag sealing cannot seal, the fault include the following:

1 heat sealing temperature is not enough, according to the packaging material and its thickness, appropriately adjust temperature.

2 heat sealing speed too fast, not easy also is associated with sealing machine speed. If too fast pincer-like device in the future and also thermalization was send traction wheel to cold area for cooling processing, natural big heat sealing quality requirements.

3 cold castor pressure is not appropriate, and each has a of cold pressing roller, and the pressure to moderate between them, only when the adjustment pressure clamping spring can be.

4 If there is water, dirt pincer-like device, the material body also is not firm.