How To Use The Continuous Band Sealer？

The first step is to wear a film. When you get the film, you need to confirm the winding direction of the film, find the counterclockwise direction, and put it on the film rod to fix continuous band sealer. (Please turn off the power when wearing the film) Please pay attention to whether the fixed splints on the front and back of the film are tightly connected with the film. After putting on the film, use adhesive tape to firmly stick the film to the receiving paper tube.

The second step, continuous band sealer operation steps (panel operation instructions). Turn on the power, turn on the power switch, the indicator light is on, set the thermostat to a predetermined temperature, then the green heating indicator light is on. When the upper hot plate reaches the predetermined temperature, the red constant temperature indicator light is on (when the sealing machine is working, the electric heating device continuously alternates in the heating and heat preservation state, so the green and red indicator lights also alternately display, which is normal).

Put the plastic cup into the lower mold slide, and push the lower mold slide to a certain position by hand (if it is an automatic continuous band sealer or an automatic sealing machine, the lower mold slide will automatically enter after the plastic cup is placed), press down The handle of the sealing machine reaches a large stroke, maintain pressure for 1~2 seconds, then slowly raise the handle and push it to the original position. Pull out the lower mold slide, take out the plastic cup, put in the final sealing plastic cup, and perform another cycle.