Do You Know How To Use Milk Tea Automatic Cup Filling Sealing Machine?

(A) milk tea automatic cup filling sealing machine wear film

a. When getting the film, confirm the winding direction of the film, find out the counterclockwise direction, and put it on the film rod to fix it. (Please turn off the power when wearing the film);

b. Pay attention to whether the fixed splint on the front and back of the film are tightly combined with the film.

c. After putting on the adhesive film, stick the adhesive film firmly on the receiving paper tube with adhesive tape.

(Two) milk tea automatic cup filling sealing machine operation steps (panel operation instructions)

a. Turn on the power, turn on the power switch, the indicator light is on, the lower mold slides out of the machine and sets the temperature controller to a predetermined temperature. At this time, the green heating indicator light is on. When the upper hot plate reaches the predetermined temperature, the red constant temperature indicator light is on (the electric heating device alternates between the heating and holding states when the sealing machine is working, so the green and red indicator lights are constantly displayed alternately, which is normal)

b. Put the plastic cup into the lower mold slide, press the fully automatic control switch, the lower mold slide automatically enters, touches the rear stroke switch, the upper mold automatically presses the seal after receiving the signal, and touches the lower stroke switch to delay the protection. Press for one second, it will automatically rise and reset. When the upper stroke switch is touched, the upper mold motor stops. The film motor starts to rotate, after a predetermined length, the film motor is automatically stopped by the electric eye. Pressing the semi-automatic control switch, you need to press the start button. Just started a cycle;

c. If the stop button is pressed in any case, the lower die slides out of the milk tea automatic cup filling sealing machine automatically.